Because they usually do not require lubrication, linear sleeve bearings outperform linear ball bearings in dirty environments.

A ceramic liner makes high speeds as well as rapid acceleration and deceleration possible.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

These fiberglass bearings are lightweight, nonmagnetic, and won’t conduct electricity.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

Virtually maintenance free, these bearings have slippery, chemical-resistant liners that don't require added lubrication.

Made from a single piece of slippery UHMW plastic, these bearings have no cracks or crevices so they’re easy to clean.

With two bearings mounted in one housing, these sleeve bearings can handle heavier loads than standard mounted linear sleeve bearings.

The Frelon liner on these bearings allows them to stand up to a wider range of chemicals than other flange-mounted linear sleeve bearings.

Virtually maintenance free, these bearings have slippery, chemical-resistant liners that don't require added lubrication.

With two bearings mounted in a single housing, these bearings have higher load capacities than standard ones. A ceramic liner helps them achieve high speeds as well as rapid acceleration and deceleration.

Slide up to two linear ball or sleeve bearings into these housings and secure them with the included internal retaining rings.

With a wide base, these sleeve bearing carriages stabilize moment (twisting) and off-center loads better than standard carriages. Use in areas where multiple carriages or rails won't fit.

With fewer moving parts and no need for lubrication, sleeve bearing carriages perform better in dusty and wet environments than ball and roller bearing carriages. They're also better at handling impact and vibration.

Use these carriages and guide rails in temperatures up to 300° F.

Threaded inserts secure the bearing to the carriage and prevent it from loosening due to frequent starts and stops.

Fasten loads on the side of these carriages and add linear motion to a T-slot assembly.

For applications with low clearance, these carriages protrude less than 5 mm above their rails.