Because these grips resist absorbing water, they are less likely to crack or corrode than other types of plastics and metals.

Secure installed cords in wet environments with temperatures up to 300° F while guarding them against sharp bends. These PVDF grips stand up to corrosion, chemicals, and heat, making them good for use in food and beverage plants as well as clean rooms that require high-temperature sanitizing.

A rubber bushing with an oval slot resists water and provides entry for building cable, which is also known as Romex type NM-B or type UF-B cable.

Snap these cord grips into place to secure cable in wet environments.

Keep moisture out of your enclosure while securing cords in wet environments. Made of polyamide, these grips are lightweight.

Tighten the screw-down clamp for superior pull-out resistance.

Prevent installed cords from coming loose in washdown and other wet environments.

These grips have an extension that provides extra support for moving cable and prevents kinking for longer cable life.

Secure cable installed through enclosures in wet environments while venting air to protect electronics from condensation.

Good for wet areas where space is tight, these lightweight grips secure cords at a 90° angle while reducing the stress from bending. Made of aluminum, they’re lighter in weight than steel and brass grips yet durable.

Use these lightweight grips to secure cords entering knockouts at a 45° angle in wet, tight spaces while easing the stress from bending. Made of aluminum, they’re lighter in weight than steel and brass grips yet durable.

With an oval bushing hole, these lightweight grips secure flat building cable, such as Romex and Festoon cable, in wet areas. All offer strain relief to extend cable life.

These cord grips are lightweight yet durable. They have a zinc-plated steel locknut and metal-reinforced rubber O-ring that prevents liquid from entering the connection.

Made of nylon, these grips resist chemicals. Install them in panels and enclosures—they have a zinc-plated steel locknut and metal-reinforced rubber O-ring that prevents liquid from entering the enclosure.

Made of nylon, these grips resist chemicals. Install them in panels and enclosures—they have a zinc-plated steel locknut and metal-reinforced rubber O-ring that prevents liquid from entering the enclosure.

The mesh offers a secure hold in applications where cable is pulled or in motion. It reduces stress on the cable and prevents kinking for longer cable life.

Stronger than aluminum cord grips, these steel grips are zinc plated for corrosion resistance. They have a steel locknut and metal-reinforced O-ring that prevents liquid from entering the connection.

These grips are nickel-plated brass for good corrosion resistance.

These 90° elbows meet Class III, Divisions 1 and 2 standards for use in hazardous locations.

The face of these grips is flush with the cable-entry point for a seamless appearance. They have a thin, flexible seal that covers the holes until you push a cord through.

Peel away layers of rubber inserts to fit around cord grips, even when you don't know the exact diameter.

The face of these grips is flush with the cable-entry point for a seamless appearance.

Secure multiple flat cable through one cord grip—reducing the space and number you need for a project, as well as saving time.