Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

Keep these shaft collars in place by tightening their set screw into the shaft.

These metal collars are stronger than plastic shaft collars.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger clamping screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Internal ball bearings allow you to slide a collar onto your shaft in one direction and then automatically lock the collar in place in the opposite direction.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

One side of these collars locks down like a standard one-piece shaft collar; the other has a flush face that's flat to 0.0005", which lets you mount the collars on a shaft next to precision bearings, sprockets, and gears.

Offering the benefits of a two-piece collar in a one-piece design, these collars swing open for positioning then close anywhere on your shaft.

These collars have two different sides—one locks down like a standard clamping shaft collar; the other has a flush face that you can machine to add slots, holes, and grooves to match your special setups.

To install, slide these one-piece collars onto the end of your shaft.

Secure items to either side of these collars—each half has a flat end with a tapped hole

To install, thread these one-piece collars onto the end of your shaft.

Install these two-piece collars square shafts.

To install, slide these one-piece collars onto the end of your shaft.

With a nylon insert that grips your threaded shaft or spindle without damaging its threads, these locknuts—also called shaft nuts—hold bearings, bushings, gears, and pulleys prone to vibration tightly in place.

These threaded handles take the place of a set screw, allowing you to move set screw shaft collars without additional tools—useful for when the collar serves as a stroke limiter or mounting clamp.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Slide these one-piece collars onto the end of your shaft to create an end-stop for linear components.

Mount these two-piece collars anywhere on an Acme lead screw without removing components.

Sized to fit snugly around pipe, these collars are often used to support pipe passing through floors and walls.