Toughened adhesives are blended with rubber particles for better impact resistance than standard epoxies. They form flexible, resilient bonds.

With excellent resistance to corrosive chemicals and salt water, these epoxies work in tough conditions.

For quick repairs, these epoxies begin to harden in 6 minutes or less.

Urethane adhesives are the most flexible, so they bond dissimilar materials and damp vibration.

With excellent shear strength, these acrylics form bonds at least 25% stronger than standard acrylic structural adhesives.

To keep these adhesives from squeezing out during clamping and give a consistent bond thickness, they're mixed with small glass beads.

Mixed with rubber for better impact resistance than standard instant-bond adhesives, these adhesives form strong, resilient bonds.

To invisibly bond transparent plastics, these adhesives won’t turn cloudy.

Accommodate joint movement with these adhesives that remain pliable when cured.

In especially damp or humid environments, these adhesives keep their hold.

These thick gels fill gaps up to 0.2" wide—the largest of any of our instant-bond adhesives.

Bond plastics, porous materials, or dirty surfaces.

Form bonds without the strong odor of other instant-bond adhesives.

For faster bonding, these adhesives begin to harden in half the time of our other wicking instant-bond adhesives.

For flexible bonds that resist cracking, these adhesives stay pliable.

Screw the gun onto a bottle of Loctite® threadlocker or retaining compound, then set the dial to control the amount being dispensed.

To speed cure time on coated fasteners, aluminum, stainless steel, or titanium, apply these primers before using threadlocker or retaining compound. They also work with no-mix acrylic adhesives.

Shorten the time it takes instant-bond adhesives to reach full strength.

Even on oily surfaces, these retaining compounds keep their hold.

Fill gaps up to 0.02" to secure worn unthreaded cylindrical metal parts such as shafts, bearings, and press-fit assemblies.

These threadlockers meet NSF/ANSI 61 for drinking water.

Use these threadlockers on fasteners that require occasional fine-tuning, such as set screws.

These low-friction threadlockers harden slowly, allowing ample time to smoothly adjust multiple large bolts for even clamping.

Withstand demanding, high-vibration applications such as motor and pump housings with these threadlockers.

This thick paste withstands temperatures up to 650 °F.

These threadlockers withstand temperatures up to 450° F.

Apply these threadlockers on fasteners that are already installed—their thin consistency allows them to flow into small gaps.

Clear enough to read through, these UV-resistant potting compounds allow optimal light transmission for use with LEDs, solar cells, and fiber optics.

This potting compound is formulated for use in sensitive applications such as manufacturing semiconductors.

Thinner than potting compounds, these rigid and wear-resistant coatings flow easily into small spaces between electrical components. Use them to secure and insulate hardware on printed circuit boards.