Sew webbing onto these plates for a permanent anchor point or run webbing through to use them as guides.

Organize multiple lines of pipe, tubing, and conduit with one clamp. Wider than standard loop clamps, multiline loop clamps surround two lines of material to create a secure grip while holding the lines close to the mounting surface. A cushion covering the clamp reduces vibration and wear from clamp edges.

Organize multiple lines of pipe, tubing, and conduit with one clamp. Wider than standard loop clamps, multiline loop clamps surround two lines of material to create a secure grip while holding the lines close to the mounting surface.

Anchor these ringbolts where you need them, then remove the ring when not in use. Once installed, the mounting bolt stays in place. Insert the ring by threading into the mounting bolt; remove by unthreading it.

Temporarily mount routing rings and other threaded components to steel and iron surfaces.

These clamps must be oriented with the saddle on the long (live) end and the U-bolt on the short (dead) end. They’re also known as wire rope clips.

Install these clamps without any specific orientation, slide the nut over the rope and tighten it onto the threaded halves with a torque wrench.

Create a choker loop around a supporting structure with the snap-hook end and use the loop to secure the suspended material.

Attach to a threaded anchor or hole for support and use the loop to secure the suspended material.

Attach the 90° eye to a surface for support and use the loop to secure the suspended material.

These slings attach quickly and securely to loads with lift attachments.

Prevent accidental opening of the hook with these locking hooks.

Grab hooks can securely hold onto a single link of chain to shorten a leg or create loops.

These two-leg slings stack steel drums vertically and horizontally.