Hold magnetic workpieces in place with these clamps.

Sized for small parts and tight spaces, these clamps have a pivoting pad at each end to hold workpieces at any angle up to 180°.

Hold and align up to three workpieces at 90° angles.

Attached to an arm you can flex into position, these clamps hold objects such as a flashlight, tool, or instructions.

The entire surface of these plates is magnetic to provide a powerful hold for grinding, drilling, and electrical discharge machining (EDM). Pull the handle to switch the magnets on and off.

Choose from flat and grooved liners.

The base is comprised of adjustable magnetic pins which allow it to conform to any shape and grip most metal surfaces.

Use a swivel clamp to attach an indicator to the positioning arm.

These magnets hold a load until you pull the handle and pry the magnet off.

Slide steel plates and blocks off a stack.

Also known as bridle rings, routing rings have an open-eye design that allows you to quickly install wire and cable.

Temporarily route material across duct, racks, machinery, and other ferrous surfaces. Clamps fit tightly around pressurized lines in hydraulic systems to lessen vibration. Rubber cushions reduce wear from clamp edges and protect lines from corrosion caused by metal-to-metal contact.

Mount these clips with the adhesive backing, then post paper and notes between the two vinyl-covered magnets.