A rubber cover protects the mounting surface as well as the magnet.

Ceramic magnets resist demagnetization better than other magnets and are an economical choice. They resist temperatures up to 480° F.

To add a magnetic surface anywhere, install the mounting plate, then screw on the magnet.

A rubber cover protects the mounting surface as well as the magnet.

Alnico magnets resist temperatures up to 420° F.

A rubber cover protects the magnet and mounting surface.

A case protects the magnetic material.

Rare earth samarium-cobalt offers a balance of strength and temperature resistance.

Turn the handle to switch these magnets on and off.

Made of neodymium, these rare earth magnets are the strongest for their size. Slide onto a rod or use a bolt or screw to install.

Ceramic magnets resist demagnetization better than other magnets and are an economical choice. They resist temperatures up to 400° F.

Cover these unfinished magnets with your choice of coating to prevent corrosion.

Many small poles give these magnets shallower, more concentrated magnetic fields that hold especially well on thin material. They resist temperatures up to 180° F.

Ceramic magnets resist demagnetization better than other magnets and are an economical choice. They resist temperatures up to 400° F.

These discs are made of corrosion-resistant ceramic and bonded with rubber for flexibility.

Stretch these magnetic strips over corners and irregular surfaces.

These magnet pairs attract for a strong hold but repel when twisted for an easy release. Use them on doors, covers, and other parts that need to be repeatedly installed and removed.

These magnets are bonded with epoxy resin, so they can be machined with carbide tooling.

Adjust the flexible arm to nearly any position.

Adjust the flexible arm to nearly any position.

For more versatility than other low-profile holders, this holder has six locations for mounting indicators and accessories, including two mounting holes and four places to mount an indicator lug back with the included thumb screws.

Use a swivel clamp to attach an indicator to the positioning arm.

Organize small parts and hand tools with these racks, which attach to steel walls, cabinets, and other magnetic surfaces.

Organize bottles of various shapes and sizes.

Twist the handle to turn the magnet on and off to easily position these hooks.

These holders keep steel tools in place magnetically.

Also known as bridle rings, routing rings have an open-eye design that allows you to quickly install wire and cable.

Temporarily route material across duct, racks, machinery, and other ferrous surfaces. Clamps fit tightly around pressurized lines in hydraulic systems to lessen vibration. Rubber cushions reduce wear from clamp edges and protect lines from corrosion caused by metal-to-metal contact.

Ball-and-socket connections allow 360° positioning.

Turn the handle to switch the magnet on and secure steel parts—no need for clamps or screws.

The entire surface of these plates is magnetic to provide a powerful hold for grinding, drilling, and electrical discharge machining (EDM). Pull the handle to switch the magnets on and off.