Remove foreign particles from food and other sanitary material with these magnetic filters. As material passes through, magnets sealed inside each rod draw metal and other contaminants out. The smooth-ground weld seams and polished surfaces are free of pits and crevices where bacteria could grow, making these filters easy to sanitize. Made from 316 stainless steel, they will not corrode from frequent washdowns with harsh cleaners. These filters are often installed in gravity hoppers, chutes, and bins in sanitary areas, such as food processing lines. They help you comply with Hazard Analysis and Critical Control Point (HACCP) programs.

Filters that are USDA certified meet the highest standards of sanitary design. With extremely smooth surfaces and no sharp corners, every inch of filter can be thoroughly cleaned. They’re polished to a minimum smoothness of 32 Ra, and corners are ground to a 0.125" radius or greater.

For technical drawings and 3-D models, click on a part number.

Pull the rods from their sleeve to release particles stuck to the filter. These filters catch fine particles such as metal filings, shavings, and residue from metal wear in your process line. Mount inside gravity hoppers, chutes, drawers, housings, and surge-and-catch bins. Magnets are sealed in rods.

For technical drawings and 3-D models, click on a part number.

Keep coolant systems free of small particles, such as chip filings and metal dust. The magnets are sealed in the rod.

Pull iron metal scrap and particles out of your process line as it moves through chutes and hoppers. Mount flush with the surface of your container; position below the flow of material.

Direct-mount filters bolt directly to chutes and hoppers. Can also be installed up to 3” above conveyor belts.

Hinged-mount filters provide access to clean the magnetic surface. You can also mount as a door on chutes and hoppers.

Draw metal shavings and other contaminants out of your sanitary liquid line with these strainers. As liquid swirls through the strainer cavity, magnets sealed inside capture any metal bits. Remaining impurities are separated out with gravity and trapped in a collection sump. Empty the strainers by removing the lid and scooping up the collected particles at the bottom of the enclosure.

Made from 316 stainless steel, these strainers will not corrode from frequent washdowns with harsh cleaners. The continuous weld seams and polished surfaces are free of pits and crevices where bacteria could grow, making them easy to sanitize. These strainers are also rated for high temperatures, so you can keep them on your line during a heated clean-in-place (CIP) process. They are FDA compliant, meaning they are safe for food contact.

For frequent deep cleans and line changes, choose a strainer with quick clamp connections. Also known as tri-clamp fittings, they connect with a gasket, a clamp, and another quick-clamp fitting for quick removal and assembly. The included gaskets are FDA compliant.

To connect strainers with flanged connections to your line, bolt two same-size flanges together with a gasket (sold separately) in between.

Filters that are USDA certified meet the highest standards of sanitary design.

For technical drawings and 3-D models, click on a part number.