Sized for small parts and tight spaces, these clamps have a pivoting pad at each end to hold workpieces at any angle up to 180°.

Each arm has a handle for turning the magnets on and off. Adjust these clamps to hold at any angle from 22° to 270° and lock the arms in place at the joint.

Two clamps connected by a pivoting arm hold workpieces at nearly any angle.

Hold and align up to three workpieces at 90° angles.

Clamp workpieces from the outside at a 90° angle, leaving the inside free for welding or fabrication. You can also clamp on the inside at 45° and 90°.

Quickly install these magnetic-backed liners to protect workpieces from marring.

Grooved liners are used for clamping uneven and round workpieces. Style E have tabs to keep the liner in place.

Fiber-coated liners are nonabsorbent and firmer than rubber.

Rubber-coated liners are slip resistant and will conform slightly to a part.

The entire surface of these plates is magnetic to provide a powerful hold for grinding, drilling, and electrical discharge machining (EDM). Pull the handle to switch the magnets on and off. Use the mounting clamps to secure the plate to your machine table and the removable back and side rails to keep your workpiece in position. Plates are sealed against dirt and liquid so they can be submerged in oil baths. They are not recommended for processes where workpieces are submerged in water.

Fine magnetic pole spacing provides the best hold on small or thin (1/4" or less) parts.

Standard magnetic pole spacing is suitable for most applications. It will provide the best grip on large or thick parts.

Attach these workstops to the side or top of your vise to position parts. Two adjustable stop pins slide in and out for precise positioning of the magnet and the part.