Position components in assemblies, as well as separate or connect parts with these standoffs.

These standoffs are made to NAS specifications.

Mount components onto food processing lines, walls, and sanitary equipment while leaving space to clean in between.

Thread the male connection into a tapped hole and snap the other end into a panel for a secure hold that can be released for repairs and upgrades.

One side inch, one side metric, and a hex in the middle—these handy fasteners connect two female-threaded parts, such as coupling nuts, adapting from inch threads to metric. Tighten with a standard wrench.

Join two female-threaded parts of various thread types and sizes, while allowing air, liquids, wire, or other thin materials to pass through.

Change thread sizes or types, such as fine to coarse threads, on parts without changing gender.

In addition to joining male- and female-threaded parts, these adapters can increase or decrease metric thread sizes and change the thread pitch.

The through hole allows you to connect float rods to float valves.

Keep a variety of standoffs in different lengths and thread sizes on hand.

Use adapters on the ends of forcing screws and face-grip puller legs when pulling shafts, bearing caps, and pinions.