Also known as mungo anchors, these have large fins that prevent rotation.

Also known as lag shields, these anchors are designed for use with large-diameter wood screws.

These 18-8 stainless steel anchors have good chemical resistance.

An open-end cap nut provides a finished appearance.

More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

Keep fixtures solidly in place—these anchors have two locking wedges that won't shake loose.

Also known as double expansion anchors, these expand from both sides for full contact and a secure hold.

Drive these tools with a hammer to expand anchors.

The fastest way to install shallow-hole female-threaded anchors. Just push the tip of the tool into the anchor and turn the tool with a power drill.

These 18-8 stainless steel anchors have good chemical resistance.

Drive these tools with a hammer until the thicker portion of the tool makes contact with the anchor, causing it to expand.

These 316 stainless steel anchors have excellent resistance to chemicals and salt water.

These anchors are also known as drive rivets. To install, hammer the pin into the body. Pry out the pin to remove.

These anchors are also known as drive rivets. To install, hammer the screw into the body. Unthread the screw to remove.

A tamper-resistant nut prevents unwanted removal of the object you are anchoring.

A zinc plating provides corrosion resistance in wet environments.

A hex head allows for a secure grip with a wrench.

A pivoting toggle bar creates a strong hold.

Used with adhesive in bricks and hollow blocks, such as cinder blocks, these mesh tubes create a stronger hold for rods and studs than other anchors.

These steel anchors are available with corrosion-resistant finishes.

18-8 stainless steel anchors have good chemical resistance.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

Attach the components of these sets onto a hammer drill to install tapping screws in concrete, block, and brick.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.

Drill holes up to 1 1/2" in diameter.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

A more controlled chip removal reduces heat buildup. Use these bits on brittle material such as block and brick.

Use these diamond-coated hollow bits for wet drilling of masonry, concrete, and rebar with a drilling rig.

The SDS-Max shank has three deep slots and two shallow slots for use with SDS-Max-drive rotary hammers.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.