These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

Attach the components of these sets onto a hammer drill to install tapping screws in concrete, block, and brick.

A zinc plating provides corrosion resistance in wet environments.

An open-end cap nut provides a finished appearance.

These 18-8 stainless steel anchors have good chemical resistance.

Keep fixtures solidly in place—these anchors have two locking wedges that won't shake loose.

Also known as mungo anchors, these have large fins that prevent rotation.

Use with any type of sheet metal or wood screw.

These anchors are also known as drive rivets. To install, hammer the pin into the body. Pry out the pin to remove.

Also known as drive rivets, install these anchors by hammering the pin into the body. Pry out the pin to remove.

A tamper-resistant nut prevents unwanted removal of the object you are anchoring.

A zinc plating provides corrosion resistance in wet environments.

These 18-8 stainless steel anchors have good chemical resistance.

A zinc plating provides corrosion resistance in wet environments.

Install like a stud anchor—just thread the anchor, a nut, and a washer onto the end of a threaded rod, drive into a hole, and turn the nut to expand the base. Also known as rod anchors, they're often used with threaded rod to hang pipe and wiring.

Also known as double expansion anchors, these expand from both sides for full contact and a secure hold.

Bolts are beveled under the head for a flush finish in countersunk holes.

For narrow holes and small cavities where toggle anchors won't fit.

Used with adhesive in bricks and hollow blocks, such as cinder blocks, these mesh tubes create a stronger hold for rods and studs than other anchors.

18-8 stainless steel anchors have good chemical resistance.

18-8 stainless steel anchors have good chemical resistance.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

Insert these bits directly into power screwdrivers, impact drivers, and other tools that accept 1/4" hex shanks.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

These bits allow you to easily switch to another size by changing only the bit body. They are hollow and cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

Drill holes up to 1 1/2" in diameter.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

The SDS-Max shank has three deep slots and two shallow slots for use with SDS-Max-drive rotary hammers.