Also known as mild steel, low-carbon steel is easy to machine, form, and weld. It's widely fabricated into parts that don’t require high strength.

Also known as mild steel, low-carbon steel is easy to machine, form, and weld. It's widely fabricated into parts that don’t require high strength.

The most widely used aluminum, 6061 is fabricated into everything from pipe fittings and containers to automotive and aerospace parts. It is strong and corrosion resistant, plus it's easy to machine and weld.

An anodized coating forms a bond with the aluminum surface to improve wear and corrosion resistance.

The most widely used aluminum, 6061 is fabricated into everything from pipe fittings and containers to automotive and aerospace parts. It is strong and corrosion resistant, plus it's easy to machine and weld.

The most widely used aluminum, 6061 is fabricated into everything from pipe fittings and containers to automotive and aerospace parts. It is strong and corrosion resistant, plus it's easy to machine and weld.

More corrosion resistant and easier to form than multipurpose 6061 aluminum, 6063 is primarily used for exterior railings, decorative trim, and door frames.

An anodized coating on these U-channels forms a bond with the aluminum surface to improve wear and corrosion resistance.

Originally developed for aircraft frames, uses for 7075 aluminum now include a wide range of high-stress parts. It is often used as a replacement for 2024 aluminum because it’s stronger and provides similar performance in all other aspects.

While 2024 aluminum was initially designed for structural components in aircraft, it's now widely used when a high strength-to-weight ratio is needed. It offers similar performance to 7075 aluminum, but it’s not as strong.

From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

Also known as angle brackets.

Strengthen corners of cases and crates.

Clamp these brackets to panel edges to quickly assemble crates.

Fit brackets together to assemble truck racks, gates, crates, and fences.

Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Pivots provide smooth motion at the junction between two T-slotted rails.

Position two strut channels at a 30° to 60° angle, then tighten the bolt to secure.

These metal guards provide more impact protection than plastic guards. Commonly used in warehouse and manufacturing areas, they protect corners on walls and other surfaces from impact.

These brackets allow you to lower your shelf 10 or 20 degrees.