Bend wire and rod up to 1/2" diameter and flat stock up to 1/4"×1" with these rugged steel benders.

Create squares, coils, and S‐shapes.

Reinforced construction lets these benders handle thicker material than bench-top benders.

Make deep folds in roofing panels and other large pieces of sheet metal.

Make bends up to 90° in metal sheets.

Save space in your shop by cutting, bending, and curving sheet metal with a single machine. Also known as shear brake rolls.

Create long, uniform folds on the edges of sheet metal.

Pull and pinch metal extrusions, such as L-channels, so they fit precisely around contoured edges and frames.

Turn your impact driver into a power crimper, and create raised edges on sheet metal more quickly than hand crimpers.

The jaws have V-notches in 1/4" increments to measure the depth of bends.

Make different edge styles on your sheet metal with these forming tools. They come with rollers for turning, wiring, burring, beading, and crimping.

Rounded jaws reduce damage to aluminum and other lightweight metal.

Bending mandrels for 1/2" to 2" tube OD are sold separately.

Use one hand to make bends up to 90° in soft metal tubing.

Protect thin-wall tubing from crimping and collapsing while bending by hand. These sets include sleeves for 6 different tube sizes.

Smoothly bend hard metal tubes, such as steel and titanium, without causing crimps or kinks.

Ratcheting action gives these tools greater leverage than standard tube benders for bending thick‐wall material.

Powerful enough to bend conduit and pipe to the angle you need with one stroke of the pump, these are for use on Schedule 40 pipe.

When you're working with exposed conduit, these benders make offset bends so your conduit matches knockout holes in electrical boxes.

Create smooth, accurate bends in round heat pipe for routing heat away from sensitive electronic components and toward a heat sink.

Also known as jeweler's hammers, these have smooth steel faces for precise forming and finishing work on delicate metal workpieces.

Use the domed end of the head for forming soft metal, rounding off edges, and closing rivets. The flat striking face is for driving nails, pins, punches, and chisels.

The face and head are made of aluminum-bronze that is Factory Mutual approved, so these tools inhibit sparking, resist corrosion, and are nonmagnetic. Use the domed end of the head for forming soft metal, rounding off edges, and closing rivets. The flat striking face is for driving nails, pins, punches, and chisels.

Place on the back side of your workpiece to act as a support when you strike it. Also known as dolly blocks.

Flatten bumps, bends, and curves on coiled wire with these straighteners.