About half the strength of medium-strength steel nuts, these nuts are for light duty fastening applications, such as securing access panels. They're zinc plated to resist corrosion in wet environments.

For technical drawings and 3-D models, click on a part number.

These nuts are half the height of standard hex nuts, and have closely spaced threads to prevent loosening from vibration. They are not compatible with coarse threads. Half as strong as medium-strength steel nuts, they are often used for light-duty applications, such as fastening signs in place.

Also known as jam nuts, they can be used in place of standard nuts when height clearances are tight, or threaded together to form a locknut. When fastening threaded rod, you can use two nuts to create a point for tightening the rod into place with a wrench. These nuts have less tensile strength than a standard hex nut when used alone.

Steel nuts are best for dry environments, since exposure to moisture and chemicals will cause them to rust.

Zinc-plated steel nuts have an outer layer of zinc that protects the inner steel from rust and extends the life of the nut.

Nuts that meet DIN 936 and ISO 4035 (formerly DIN 439B) adhere to international standards for dimensions and material composition to ensure compatibility with other products and tools. Although the DIN 936 and DIN 439B standards are no longer active, they are commonly referenced globally.

For technical drawings and 3-D models, click on a part number.

Made with fine-pitch threads, vibration is less likely to loosen these metric nuts than those with coarse-pitch threads since the threads sit closer together. Fine and coarse threads are not compatible. Also called jam nuts, they are roughly half the height of standard hex nuts, so they’re good for applications with low clearance. However, they have less tensile strength than standard height nuts. Often used as locknuts, thread two against each other to further prevent loosening caused by vibration. You can also do this on a threaded rod, which creates a gripping point so you can turn it without damaging the threads. All are 18-8 stainless steel, which is almost as strong as steel but also won’t rust in outdoor, washdown, and other corrosive environments.

DIN 936 nuts are sometimes slightly taller and wider than DIN 439B nuts. Although it’s no longer active, DIN 936 remains a commonly referenced standard for material and dimensional compatibility.

ISO 4035 nuts are functionally the same as DIN 439B nuts (sometimes also referred to as DIN 439-2), but have slightly different width tolerances. This ISO spec replaces the DIN spec, however DIN 439B is still a common reference point. These nuts have chamfered edges, so they’re less sharp than DIN 936 nuts.

For technical drawings and 3-D models, click on a part number.

These locknuts have a nylon insert that grips the bolt to resist loosening without damaging threads. They're reusable, but their holding power lessens with each use. They're about 25% stronger than medium-strength steel locknuts and comparable in strength to Class 10.9 bolts. A zinc plating provides corrosion resistance in wet environments.

For technical drawings and 3-D models, click on a part number.