Cut threads into most metal and plastic.

Tap threads for left-hand threaded fasteners.

Often used for thread repair and occasional hand tapping, these carbon steel taps can thread holes in most metal and plastic, but they have a shorter tool life than standard taps.

Keep chips clear while tapping. Also known as gun taps, these have spiral-point flutes that push chips ahead of the tap and out of through holes.

Create oversized threads while keeping chips clear. These taps are sized for use in holes where the threads will shrink due to heat treatment or plating.

Also known as cold-forming and fluteless taps, these press threads into material without cutting it, so no chips are created.

Insert these taps directly into drills, power screwdrivers, and other tools that accept a 1/4" hex shank.

With a taper chamfer and bottoming chamfer at opposite ends, these taps start threads easily and are good for threading close to the bottom of closed-end holes.

Coated with chromium carbide or titanium carbonitride (TiCN), these cobalt steel taps cut smoothly through soft material to produce accurate threads.

To tap nickel and other hard material, these cobalt steel taps have high cutting strength. Their flutes are designed to keep chips clear, so they don't need to be reversed to prevent buildup.

With a taper chamfer on one threading end and a bottoming chamfer on the other, these pipe and conduit taps can start threads easily, and they are able to thread close to the bottom of closed-end holes.

Form general purpose Acme threads.

Add threads to holes in preparation for installing helical inserts.

Restore bolt, hole, pipe, and conduit threading with this set of four files.

These taps are for use on most metal and plastic.

Sets include multiple tap sizes for threading different hole diameters.

Create pipe and conduit threads in a range of hole diameters.

Also known as gun taps, the taps in these sets have spiral-point flutes that push chips ahead of the tap and out of through holes.

Drill and tap holes in a range of diameters. With a drill bit point to drive into the workpiece, these tools can drill and tap holes in a single step. Connect them directly to drills, power screwdrivers, and other tools that accept a 1/4" hex shank.

Cut and repair threads and drill holes in many different sizes. Tap and die wrenches are included.

Repair rusted and damaged threads on any diameter bolt, stud, or rod.

Inserts come with a through-hole tap and installation tool.

Kits include helical inserts, a tap, and an installation tool.