Connect two shafts at a right angle without changing shaft speed or torque.

Use the horizontal sliding arm to make angled cuts in wider boards than a standard miter saw can handle.

Support all brands of miter saws at a comfortable working height.

This saw is less than half the weight with a smaller wheel diameter than standard bench-top cutoff saws.

Pins hold hose slightly bent, pulling it apart as the knife-edge blade slices a straight, smooth cut.

Specially designed teeth cut chips and transfer heat away from this saw's blade for smoother cuts in metal with less distortion than cutoff and chop saws.

Cut wood, plywood, and particleboard.

Also known as dado-head blades, these are for cutting grooves in all types of wood.

Use these blades for occasional cutting.

The edge of the blade is segmented to cut faster than a continuous edge.

Produce smooth cuts in plastic materials including polycarbonate, polyurethane, PVC, and acrylic with the carbide-tipped teeth on these blades.

The carbide-grit edge on these blades cuts brittle and abrasive materials including glass and fiberglass.

A continuous edge on these blades produces smooth cuts.

A razor-sharp knife edge minimizes dust and makes quick, clean cuts through foam sheets such as expanded polystyrene insulation and extruded polystyrene.

Cut stainless steel sheets, pipe, tubing, and grating with teeth made of impact-resistant carbide.

Diamond grit bonded to a segmented edge cuts through hard metal such as cast iron.

A tungsten carbide grit edge cuts through abrasive materials such as composites and fiberglass.

These blades have a continuous edge with diamond grit to cut through ceramics.

Blades and teeth are steel and treated to a Rockwell Hardness between C63 and C65 for increased wear resistance when cutting through steel and cast iron bars, rods, pipe, and tubing.

With five times the capacity of standard corner clamps, these secure two workpieces at a 90° angle.

Grip all four corners of a rectangular workpiece.

Push the lever to lock the handle and prevent accidental opening.

Sized for small parts and tight spaces, these clamps have a pivoting pad at each end to hold workpieces at any angle up to 180°.

Two clamps connected by a pivoting arm hold workpieces at nearly any angle.

Hold and align up to three workpieces at 90° angles.

Hold magnetic workpieces in place with these clamps.

An easy-to-tighten band encircles and holds round and odd-shaped objects with even pressure.

Attach to Starrett High-Accuracy Combination Square Blades with the included lockbolts.

Use these squares in place of your try square, miter square, depth gauge, height gauge, center-point finder, and level.

A titanium coating protects the blade against scratches and wear.