In addition to removing large amounts of water, these separators also remove particles and oil droplets. Place them after your compressor and aftercooler, or at the point of use in applications that don't require an aftercooler. They have an automatic drain to discharge the moisture.

For technical drawings and 3-D models, click on a part number.

When water is condensed out of a compressed air system, it contains oil from the compressor that makes disposal difficult. These separators use two-stage filtration to reduce oil content to below 20 parts per million. Check local codes for disposal requirements. The primary filter removes dirt, sludge, and most of the oil. The secondary filter removes the rest of the oil. Filters remove many synthetic lubricants that can be difficult to remove with other separators. They come with a sticker that indicates when they need to be serviced or replaced.

Separator rated to 60 scfm @ 100 psi is for one-time-use. It is compact and can be mounted to a wall or cabinet with the included brackets.

Separators rated to 120 and 360 scfm @ 100 psi have replaceable filter bags. They have a port for sampling water without disconnecting the outlet piping. Connect up to four compressed air components, such as aftercoolers, separators, and drain valves.

Replacement kits come with a primary and secondary filter bag as well as a new service indicator sticker.

Improve vacuum system efficiency and protect components from moisture—these separators remove over 90% of water from air. Typically used with vacuum pumps, they minimize vacuum pressure drop, even when the element is saturated with water. Separators have a viewing window so you can see inside to monitor water removal. Mount separator vertically for proper drainage (brackets sold separately), and install before air filters.

For technical drawings and 3-D models, click on a part number.