A cushion covering the clamp reduces vibration and wear from clamp edges. Clamps surround lines of pipe, tubing, and conduit completely while holding them close to the mounting surface.

A molded cushion reduces vibration and wear from clamp edges, plus it provides a tighter fit around material than standard vibration-damping loop clamps.

Route bundles of wire and cable through a single hook. A wide opening allows access for installation, adjustment, and removal.

Also known as bridle rings, routing rings have an open-eye design that allows you to quickly install wire and cable.

Hang cable and other flexible material beneath wire to prevent it from sagging and swaying. To install, hook the two ends of the ring around the wire—no fasteners required.

Anchor these ringbolts where you need them, then remove the ring when not in use. Once installed, the mounting bolt stays in place. Insert the ring by threading into the mounting bolt; remove by unthreading it.

Mount to a surface to secure and route cable.

Reduce gaps between the cable tie and bundle—these ties have a smooth body that allows them to adjust to the exact size of the material.

Quickly attach and detach a bundle.

Route and organize wire, cable, and hose along your DIN rail. Unlike zip ties, these cable ties can be temporarily undone to add or remove material.

The hinged snap-on crossbars open for access at any point along the carrier's length so you can lay in the cable and hose, rather than threading it through.

Designed for smooth, quiet travel, these carriers minimize clicking and jumping in vibration-sensitive applications such as printing and scanning.

By completely surrounding the cable and hose, these carriers protect them from dirt, chips, and debris.