Run cable and tubing in the tightest spaces with channel that is one-quarter the height and one-half the width of regular strut channel.

Half the height and the same width as regular strut channel, this low-profile strut channel fits into tight spots and is compatible with many of the same brackets.

Slide the strut channel into the tube for telescoping length adjustments.

This welded, one-piece strut channel combines two strut channels back-to-back.

Create continuous runs of channel without corners.

Push these brackets into strut channel and tighten the included cam screws for a partially concealed connection.

Serrated grooves grip the lip of the channel.

Insert these nuts into the long open side of strut channel and twist to secure. A built-in washer enables one-handed installation.

When there's no access to the open side of a strut channel, slip one of these nuts through a slotted hole and turn it 90° to secure it in the channel.

There's no need for additional fasteners with these nuts—they combine a strut channel nut with a spring and a threaded stud.

Push these nuts into place rather than threading them onto a fastener.

Connect two channels to create a stacked channel.

Notches on these washers grip the channel to keep them in place.

Add hardware to strut channel without having to hold the washer in place or reach inside the channel.

Provide a stable, nonmarring base for strut channel legs.

Brackets mount on the outside of strut channel to allow trolley movement.

A tab on the end of these shelf brackets fits inside the strut channel for extra stability.

For quick mounting of components, these hangers snap into strut channels for a strong hold and easy repositioning.

Slip these hangers onto the lip of top-opening strut channel to attach chain, wire rope, pipe, and threaded rod.

Mount terminal blocks, power supplies, relays, and other control and distribution devices on walls and other flat surfaces and in enclosures.

Position terminal blocks, relays, and other components mounted to DIN rails with these stops and spacers.

Stick this DIN rail in any enclosure to mount components without making screw holes that might leak.

Protect development boards from dust, water, and debris by mounting them to DIN rails inside control cabinets.

Reduce noise caused by HVAC systems. These sturdy rubber supports isolate vibration caused by heat pumps and air conditioning units, resulting in a quieter facility. When used on roofs, they also keep components above puddled water, which can cause damage.