A mounting plate provides a more secure hold at the mounting surface.

A durable rubber cushion and mounting plate prevent corrosion and wear caused by metal-to-metal contact. The mounting plate is removable, so the U-bolts can be installed onto an existing line without needing to dissemble it.

The ring pivots 90° or 180° to secure loads in various directions.

Dimples hold the base tight to prevent it from swiveling.

Adhesive on the back holds these rings in place.

Sockets mount to the inside corners of angle iron and channel to provide a threaded mounting hole for stem casters.

Thread one of these plates onto your ram and use the four mounting holes to secure it in place.

Machine holes and slots or weld in place.

Machine holes and slots or weld in place.

Machine holes and slots or weld in place.

Also known as angle brackets.

A rubber seal protects against moisture around the installation hole.

Clamp these brackets to panel edges to quickly assemble crates.

The two-piece design accommodates a wide range of panel thicknesses.

Interlock brackets to secure panels flush to flat surfaces.

Fit brackets together to assemble truck racks, gates, crates, and fences.

Attach sensors, tubes, and other components to T-slotted framing rails and structures.

Securely fasten strut channel to the floor.

Mount a length of strut channel between the ends of a beam to run cable and conduit along the beam without drilling.

Designed to wrap around the sides of strut channel, these brackets provide a stronger hold than other strut channel brackets.

Rails are drilled with consistently spaced holes for multiple mounting options that do not require machining. Use this steel bolt-together framing to build guards, tables, and racks.

Add a flat mounting surface to to a screw jack to support loads.

Install components and make electrical connections on a panel, then mount the panel in your enclosure. Using a panel means you won’t need to make holes in the body of your enclosure, which could let in dust and water.

Protect development boards from dust, water, and debris by mounting them to DIN rails inside control cabinets.

Install these mounts on machines without feet.

Elevate robot arms with these bases so they can reach onto raised surfaces, such as conveyor belts or workstations.

Take your Universal Robots arm to new heights—these bases move up and down to extend your robot’s vertical reach for high and low stacking jobs.

To minimize strain on your door strips, these plates have a hinge that swings when personnel or vehicles pass through.

These flanges can mount on either end of the hydraulic cylinder.

For easy interchangeability, the mounting footprints of these cylinders meet NFPA and JIC industry standards.