Crimp these fittings onto steel pipe to form a tightly sealed connection that’s faster than threading or welding and doesn’t require heat.

Low-profile barbs and a longer first barb allow for a smoother, easier installation than other barbed fittings. Slide the barbed end into hose and secure with a clamp.

Couplings allow for maximum flow because there's no shut-off valve in the plug or the socket. Compatible with Open-Flow-shape plugs and sockets.

Compatible with ARO-shape plugs and sockets.

Compatible with Japanese-shape plugs and sockets.

Compatible with Lincoln-shape plugs and sockets.

Compatible with Ring-Lock-shape plugs and sockets.

Also known as Thor couplings, these have two locking points to give you twice the gripping power of standard grip-lock couplings. They consist of a plug and a socket that connect with a quarter twist.

Fittings are threaded on both ends so you can connect them directly to a threaded hose or to pumps, cylinders, and other equipment in your hydraulic system.

Fittings have sharp barbs that grip push-on hose with no clamps or ferrules required. The more you pull on the fittings, the tighter the hose will grip. Use in low-pressure hydraulic applications up to 350 psi.

Crimp these fittings onto hydraulic hose for a permanent, leak-tight connection. Since they crimp on, they handle higher pressure than screw-on fittings.

Use these couplings at pressures up to 3,000 psi. They consist of a plug and socket that connect and disconnect quickly. Use them if you need frequent access to a line. They are compatible with Pioneer-shape plugs and sockets.

Use these couplings at pressures up to 10,000 psi. Also known as flush-face couplings, the plugs and sockets have a flat face, which allows them to mate close together, reducing fluid loss when connecting and disconnecting the line. They are compatible with High-Pressure Minimal-Spill-shape plugs and sockets.

Use these couplings at pressures up to 6,500 psi. They consist of a plug and socket that connect and disconnect quickly. Use them if you need frequent access to a line. They are compatible with Snap-Tite H-Shape plugs and sockets.

Use these couplings at pressures up to 10,000 psi. The plug and socket thread together to form a stronger connection than other quick-disconnect couplings. They are compatible with High-Pressure Thread-Lock-shape plugs and sockets.

Couplings consist of a plug and a socket that connect and disconnect quickly. Use them if you need frequent access to a line. They are designed for coolant applications up to 200 psi. Also known as coolant-line mold couplings.

Also known as ground-joint couplings and boss couplings, these fittings are designed for high-pressure steam applications up to 600 psi. Insert the barbed end of the fitting into hose, then position the interlocking clamp over the hose and bolt into place. The clamp firmly grips your hose as it locks into the ring of the barbed end, creating a leak-tight seal.

These fittings have two sleeves for extra gripping power. They bite into steel tubing as you tighten the nut to form a strong seal.

Keep thin grease from leaking out—the check valve on these fittings has a Buna-N seat that creates a tighter seal than check valves on other grease fittings.

Keep a variety of grease fitting shapes, styles, and sizes on hand.

The nipple doesn't stick out, so these fittings fit in tight spaces and won't be damaged if something knocks into them.

Drive these fittings into unthreaded holes.

Since they don’t protrude, these fittings avoid damage from impact and fit in tight spaces. Use a hammer and grease fitting installation tool to drive them into unthreaded holes.