About half the height of standard-profile locknuts, these fit in spaces with low clearance. You can also use them as jam nuts by threading them against a hex nut to hold it in place. The nylon insert grips the screw to prevent loosening from moderate vibration without damaging threads. However, the insert may become brittle if exposed to high temperatures. These locknuts are reusable a handful of times, but the holding power decreases with each use.

To save on assembly time, these locknuts combine a hex nut with a free-spinning lock washer, so you can twist them into place by hand. Once the nut is against your material surface, tighten it down with a wrench or socket to get the teeth to bite. Although these nuts install more quickly than nylon-insert locknuts, they don't hold up as well against vibration and can mar your material. As long as the washer stays intact, you can reuse them. Also known as Keps and K-lock nuts.

Serrations bite into material for mild vibration resistance while the flange eliminates the need for a separate washer. These nuts are ideal for securing screws in oversized or irregularly shaped holes since the flange covers a larger area than standard nuts. You can use them again and again without sacrificing strength. However, the serrations may mar the surface of your material. Also known as collar nuts.

The strongest hold of all the flange nuts we offer, these have irregularly shaped threads that grip the screw to resist loosening. The threads prevent the nut from backing out due to high vibration, but they also increase the effort to install and remove. To get these nuts off, you may need special tools, such as an impact wrench or propane torch, so they are not reusable. Nuts have a flange that distributes pressure evenly across the mounting surface without the need for a separate washer. They are ideal for securing screws in oversized or irregularly shaped holes since the flange covers a larger area than standard nuts. Also known as collar nuts.