Use these plastic fittings to connect gasoline fuel lines to machines and equipment. They have excellent corrosion resistance as well as high strength and impact resistance.

Made of brass, these fittings have good corrosion resistance.

Minimize leaks in your line—these fittings have a single barb that creates a smooth clamping surface for extra-tight connections.

A built-in shut-off valve stops the flow when the coupling is separated, so there’s no need to worry about air or water spilling from your line. Couplings are plastic, which is lighter in weight than metal couplings.

Couplings are plastic, which is lighter in weight than metal cam-and-groove hose couplings. They consist of a plug and a socket that connect and disconnect quickly. Use them if you need frequent access to a line. To connect, insert the plug into the socket and push the levers down.

Instead of tossing Ethernet cords with a broken locking tab on their RJ45 plug, fix them with these clips.

Designed to withstand washdown and outdoor environments, these connectors have a seal to block out water and debris.

Safeguard internally threaded BSPT connections from contaminants during fabrication and storage.

Vents in the top allow air circulation and permit heat and fumes to escape. These plugs have tapered prongs that snap into the hole to securely hold them in place.

Vents in the top allow air circulation and permit heat and fumes to escape. All of these plugs have wings that expand against the sides of the hole to lock them in place.

Use these vents to maintain consistent pressure as temperatures fluctuate by allowing air to flow through sealed enclosures.

These vents have louvers with foam filters to keep out dust and falling liquids.

Safe for use around hazardous gasses and dust, these vents maintain steady pressure and prevent moisture buildup from temperature changes inside enclosures.

Close off unused switches and outlets.

A rubber bushing with an oval slot resists water and provides entry for building cable, which is also known as Romex type NM-B or type UF-B cable.

Tighten the screw-down clamp for superior pull-out resistance.

These grips are made of nylon, which resists most chemicals. The nylon mesh extension provides a secure hold when the cable is pulled or in motion.

These grips install into enclosure holes quickly to stabilize and relieve strain on cords.

Made of nylon, these grips resist chemicals.

Also known as cable-entry seals, the cable-entry side has heat-shrinkable polyolefin with an adhesive lining.

These grips have a thin, flexible seal that covers the holes until you push cords through.

Grips have a rubber inner grommet with multiple holes and a rubber O-ring that create a tight seal to prevent liquid from entering the connection.

The cable-entry side has heat-shrinkable polyolefin with an adhesive lining. These are also known as cable-entry seals.

A spring extension prevents sharp bends and kinks in your cord, prolonging its life. These bushings, which are more rigid than grommets, shield cords from rubbing against the edges of holes in enclosures and panels, so they won’t wear down.

These grommets snap into place and have wings that expand against the sides of the hole to lock them in position. Use them to protect wire, cable, and cords by turning rough-edged and uneven holes into smooth holes.

Support shafts, bearings, and other moving parts that are routed through a hole. These grommets are slippery to allow parts to move freely in the hole. Install them on thin sheet-metal panels.

A flexible shank allows these rivets to be removed and reused. You need access to only one side of the material to install.