A braid reinforcement gives this tubing excellent strength in high-pressure applications up to 250 psi.

Excellent strength and durability allow this tubing to handle high-pressure air and water applications up to 950 psi.

This self-extinguishing tubing meets UL 94 V-0 or UL 94 V-2 for flame retardance to delay the spread of flames to valuable equipment.

Hard walls give this tubing the strength to handle high-pressure fuel and gasoline applications.

Made of brass, these fittings have good corrosion resistance.

Barbs grip onto tubing.

You don't need a clamp to secure these fittings to tubing. They have a nut on the barbed end that tightens to holds the tubing in place.

A built-in shut-off valve stops the flow when the coupling is separated, so there’s no need to worry about air or water spilling from your line. Couplings are plastic, which is lighter in weight than metal couplings.

Use these clamps with quick-clamp fittings for dairy to quickly connect and disconnect your line as needed.

With an easy-to-cut hose and push-to-connect fittings, you can install a compressed air line system in just a few hours.

Made of thick, rigid nylon, this hose has excellent durability and the highest pressure rating of the retracting hose we offer.

Made of nylon, this hose is lighter and easier to maneuver than rubber hydraulic hose.

Also known as nylon 6/6, this general purpose material is often used for bearings, gears, valve seats, and other high-wear parts.

This nylon stays lubricated over time because it’s filled with oil. Use it to fabricate parts for hard-to-reach places where adding lubricants would be difficult.

Braided from thick plastic strands, this sleeving has excellent abrasion resistance. It stretches to fit over items for easy installation, then tightens around its contents for a secure fit.

This sleeving reflects heat away from contents and withstands temperatures up to 300°F. A slit along the length makes it easy to install over wire, cable, and hose without disconnecting them. The corrugated construction gives it impact and abrasion resistance similar to conduit, with more flexibility.

Made with a self-extinguishing additive, this sleeving will not produce fumes when exposed to open flame or high temperatures. A reusable alternative to tape and cable ties, it allows you to route wire and cable between the spirals.

Make tight bends in machine and equipment wiring.

Preventing wear and cracks, these grommets shield the sections of your conduit that rub and bang against nearby components.

Join pieces of conduit.

Attach conduit to a knockout in an outlet box or enclosure.

Covered with a copper braid, this conduit protects wire and cable from electromagnetic interference (EMI) caused by motors and other equipment.

One end twists into a piece of conduit for a quick connection; the other end attaches to a knockout in an outlet box or enclosure.

More rigid than grommets, these bushings guard cords from rubbing against the edges of holes in enclosures and panels and wearing down.

Seal T-slots, rail ends, and gaps between rails to keep out dust, debris, and other contaminants.

A slit in the side of these grommets allows you to install them around wire, cable, and cords that are already in place. They snap into the hole and their wings hold them tight. Use them to turn rough-edged and uneven holes into smooth, insulated holes.

The center hole has flaps that flex to hold and protect various sizes of wire, cable, and cords while keeping out dust and debris. Snap these grommets into place and their wings expand against the sides of the hole to lock them in position. Use them to turn rough-edged and uneven holes into smooth holes.