Made from MDS-filled PTFE for a slippery surface, these wipers allow rods to move three times faster than other rod wipers.

Made from PTFE, these wear rings have a slippery surface that allows rods to move at least three times faster than nylon wear rings.

These seals require lighter packing pressure than standard oil- and water-resistant packing seals, so they cause less friction and reduce shaft wear. They’re made of graphite-impregnated aramid fiber and are for use in pumps and valves.

Made of graphite-impregnated carbon, these steam-resistant seals dissipate heat from the shaft to protect pumps and valves when operating at high speeds.

Use these graphite-impregnated graphite seals for steam applications in pumps and valves.

Secure cords installed through enclosures and panels in wet environments while protecting them against sharp bends. With a flared end that keeps cords from bending without limiting too much motion, these grips extend cord life.

These grips are made of nylon, which resists most chemicals. The nylon mesh extension provides a secure hold when the cable is pulled or in motion.

Made of nylon, these grips resist chemicals.

Made of nylon, these grips resist chemicals. Install them in panels and enclosures—they have a zinc-plated steel locknut and metal-reinforced rubber O-ring that prevents liquid from entering the enclosure.

Attach a cord grip to cable without removing connectors and rewiring. These cord grips have a two-piece design to fit around cables with connectors.

The face of these grips is flush with the cable-entry point for a seamless appearance.