Calibrated, cleaned, and bagged for oxygen service, these flowmeters are commonly used for welding. They install directly in your line. All have a flow-control knob that lets you open and close the valve at the inlet to adjust the flow rate within the range.

For technical drawings and 3-D models, click on a part number.

These valves automatically reduce a high inlet pressure from compressed gas tanks to a lower, stable outlet pressure. All have Compressed Gas Association (CGA) numbered inlet fittings for secure connections to compressed gas tanks. Choose a valve with the same CGA number as your tank and other system components. Valves have a gauge to monitor outlet pressure and a gauge to monitor inlet pressure from the tank.

Choose a valve with a maximum outlet pressure that’s approximately twice your application’s normal operating pressure. Your operating pressure should never exceed 75% of the valve’s maximum outlet pressure.

Single-stage valves reduce pressure in one step, which causes the outlet pressure to fluctuate slightly as you empty the tank. They’re best for applications where a constant outlet pressure isn’t critical.

Two-stage valves progressively reduce pressure over two steps for more consistent outlet pressure at all times. They’re often used in applications that require a constant outlet pressure regardless of the tank level.

Valves with a brass body have a longer service life than valves with a brass and steel body.

Valves with a stainless steel diaphragm can withstand harsh environments.