A rubber seal protects these switches from splashing water.

Built into a terminal block, these switches mount to DIN rail.

Able to withstand splashing, dirt, and high vibration, these switches meet MIL-S-83731. They're half the size of most toggle switches to maximize the space in a panel.

Able to withstand high currents, these switches are often used with motors and pumps.

Rated IP67 for protection from dust and temporary submersion.

Able to withstand high currents, these switches are often used with motors and pumps.

Maximize space in a panel—these switches are smaller than most standard rocker switches.

Often used in large, open workspaces, these switches can be wired on opposite ends of the room to control the brightness of lights on the same circuit. They're also known as three-way switches.

Instead of hardwiring power supplies, appliances, and other electronic devices, these connectors let you plug in an IEC power cord and turn the power on and off without needing a separate switch.

In addition to protecting equipment, these circuit breakers can be used as on/off switches. They can handle high inrush current found in motor start-ups.

At half the height of standard insertion flow switches, these are often used in low-clearance areas.

For installation in environments with flammable gases and combustible dust, these flow switches are UL listed for use in hazardous locations.