Combine the high wear resistance of a cast iron face with the ease of welding a low-carbon steel base. You'll often see these wear plates used on backhoe and excavator bucket teeth, but you can use them anywhere you need to protect equipment from heavy abrasion, friction, and impact. Also known as chocky bars because they resemble a chocolate bar, these plates can be shortened by breaking off sections. Cut through the low-carbon base at a scored section, then wrap the plate with a cloth and hit it with a hammer to break the cast iron side.

All adjustments can be made from one end, allowing clamping in tight spaces. Place the arms on a pipe that is threaded at one end and at least 12" long to create your own bar clamp. The clamping surfaces have removable plastic pads that prevent damage to material. These are also known as pipe clamps.

A two-piece design requires less clearance to install than one-piece mounts. Raise your machine just enough to slide the base underneath, then insert the stud from above through a threaded or unthreaded hole. The stud rests in a divot in the base and swivels to keep equipment level on slightly sloped and pitted floors. Mounts also have a rubber cushion that reduces vibration to protect components and extend your machine’s life.

The highest capacity vibration-damping mounts we offer. The rubber or felt cushion reduces vibration to protect components and extend your machine’s life. Rest large equipment, such as CNC and injection molding machines, on top of these mounts and the weight will keep them in place. Turn the hex head bolt with a wrench to adjust the height and angle.

Absorb higher-intensity shocks and vibration than mounts without springs. These mounts compress (deflect) four times farther than other mounts when force is applied to protect shaking, thudding machinery and nearby equipment. They also dissipate the low, slow-moving vibrations other mounts can't handle, such as the rumbling of traffic or a large air compressor.

Keep sliding doors and panels from damaging walls and door frames. Mount these stops with screws.

The highest capacity mounts we offer, these support up to 110,000 lbs. to level heavy machinery. Rest large equipment, such as CNC and injection molding machines, on top of these mounts and the weight will keep them in place. Turn the hex head bolt with a wrench to adjust the height and angle.

Flip holders down to keep doors open; flip up to release. All have a nonmarring, replaceable rubber pad.

Ductile cast iron is strong, resilient, and able to handle repeated stress without breaking. It also absorbs vibration, so finished parts run quieter than those made of steel.

Gray cast iron machines faster with less wear on cutting tools than most types of steel. It also absorbs vibration, so finished parts run quieter than those made of steel. It's often fabricated into gears, pulleys, and bushings.