Spring action provides significant isolation of vibration and noise.

Industrial-strength metal bumpers bounce back from impact caused by forklifts and small trucks. Install them individually, side-by-side, or one above the other on one or both sides of your door.

Hardwire these switches to automatic door openers, electromagnetic locks, and electric strikes and your door will open at the touch of a button or the wave of your hand.

Use steel wool for a range of surface preparation tasks, from removing paint and rust to polishing for a fine finish.

Use these buttons to support and position workpieces and fixtures from the bottom or side. Their hex shape lets you screw them into a threaded hole with a wrench or socket.

Mount through the counterbored hole with a socket head cap screw to support and position workpieces and fixtures from the bottom or side.

Support rounded or irregularly shaped workpieces from the bottom or side with minimal contact.

Maintain a secure hold on uneven or irregularly shaped parts by clamping against these serrated grippers.

The face of these grippers is angled 15°. They can be used in the jaws of lathe chucks.

Sized to fit with precision in machine table T-slots, use these keys to locate fixtures and vises on your machine table.

For locating the side of a workpiece without milling a permanent slot into your fixture, screw these easily repositioned rails into threaded holes.

Slide these low-profile supports under a workpiece to provide support and reduce vibration.

The contact area is covered in plastic to protect soft metal and polished surfaces. Attach these tips to the end of a screw or threaded stud to apply uniform pressure on uneven and angled surfaces. Also known as toggle and swivel-foot pads.

Mount to a surface and add a cable tie to secure a bundle.

Cut this stock into custom shapes to fit your application.

Cut this shim stock into custom shapes to fit your application. Stock is made of layers of material bonded with adhesive; remove layers with a utility knife until you get the thickness you need.

Be prepared with ring shims in a variety of thicknesses. These shims fit around fasteners and shafts to precisely align, level, and adjust spacing.

For a snug fit around a shaft, the ID of these shims is held to a tighter tolerance than other round shims.

Use these round shims as they are, or punch out the middle to create the ID you need.

These shims are shaped to fit over D-profile shafts. Use them to precisely align, level, and adjust spacing.

Be prepared with shims in a variety of thicknesses. These shims are shaped to fit over D-profile shafts. Use them to precisely align, level, and adjust spacing.

Spin these shims onto screw threads to extend the shoulder length.

Use a single shim on feet or positioning arms that are secured with multiple fasteners. The slots let you insert, remove, and adjust the shims without disassembling your machinery. Also known as finger shims.

The tip is narrow to pass through threaded holes.

A low-profile flat-faced ball tip allows these metric set screw to be used in low-clearance applications.

A rolling ball swivels 360° to minimize surface damage and allow for slight adjustments without loosening the screw.

For maximum contact with angled and uneven surfaces, the tip swivels in all directions. The tip is narrow so it will fit through threaded holes.

Slide onto a shoulder screw to shorten the length of the shoulder.

Spin these tight-fitting shims onto your screw's threads to lengthen the shoulder.