Touch up scratches and wear on powder-coated metal without a primer. Choose the color that matches your equipment—this paint matches some of the most common colors used in powder-coating applications.

Unlike paint that must be diluted, this paint comes ready for use with an air brush.

This chalk disappears in approximately 15 days when exposed to water, traffic, or abrasion.

This zero-VOC paint is for use in enclosed occupied areas, such as hospitals, schools, and offices.

This water-based paint sprays in an inverted position and will not harm grass or other plant life.

Used to insulate, create grips, and color-code components, these coatings resist high temperatures, light abrasion, and corrosion.

Use these dyes after anodizing and before sealing to add a decorative appearance.

No mixing required—these potting compounds come ready to apply.

To effectively dissipate heat in the tightest spaces, this coating contains a filler that acts like a shim to produce a consistent 0.005" to 0.006" gap between components.

For use in processing equipment that carries large particles 1/16" in diameter and larger, these ceramic-filled epoxies rebuild and repair surfaces exposed to abrasion from particles, such as pump housings, chute linings, and hoppers.

Choose only the colors you need.

Choose only the colors you need. These paint markers work well even on dirty, rusty, and oily surfaces.

Good for wet environments, the writing from these markers won't come off with water alone.

Low in chlorides and halogens, these markers won't corrode or contaminate surfaces where degradation is a concern such as stainless steel. They're typically used in nuclear plants and oil and gas refineries.

These paint crayons work well even on dirty, rusty, and oily surfaces.

Often used for structural steel parts or layout work, markings from these crayons show through oil- and solvent-based primer coatings. Works on metal surfaces.

Write on glass, metal, paper, and wood.

Identify high spots, interference points, and improper fit on bearings, gears, and valves.

Brush on this liquid to mask small surfaces and irregular shapes.

Made of polyester plastic, this tape resists tearing in high-temperature masking jobs, such as on circuit boards and when powder coating.

Outline and draw attention to safety zones and hazards with this tape.

Seal and mask rough surfaces such as concrete and stucco with this tape. The adhesive removes cleanly, even after long-term exposure to moisture and UV light.