Pair with a barrel you already have or couple with a different barrel to create a custom fastener. Made from 316 stainless steel, they have excellent chemical resistance and can be used in saltwater environments.

These include a barrel and a screw.

Use these barrels with a screw you already have or pair with a different type of screw to create a custom fastener. Made from 18-8 stainless steel, they are chemical resistant.

Shorter than shoulder screws for use in thin material.

Use these barrels with a screw you already have or pair with a different type of screw to create a custom fastener. They're zinc plated to resist corrosion in wet environments.

An unthreaded barrel allows quick assembly with a press or a hammer.

Install in a cutout to create a secure joint between boards, butcher blocks, and countertops.

Stainless steel binding barrels and screws have excellent corrosion resistance in most environments.

One-third the weight of steel, aluminum binding barrels and screws resist corrosion in wet environments.

Add length to a binding barrel.

Brass binding barrels and screws are corrosion resistant in wet environments and electrically conductive.

Brass binding barrels and screws are corrosion resistant in wet environments and electrically conductive.

Angled under the head for a flush finish in countersunk holes.

Install these binding barrels and screws with a standard slotted screwdriver. They require a special tool to remove.

Install these thumb-screw-head screws through a hole and thread on a retainer to keep secure—no special tools are required.

Press these rounded head nuts into the backside of a panel in applications where you have access to both sides of the panel. A quarter-turn locks and releases access panels, doors, and covers.

Press these rounded head nuts into a closed-end hole or thick panel in applications where the back of the panel is inaccessible. A quarter-turn locks and releases access panels, doors, and covers.

These wing-head screws have a clip-on nut that allows you to mount them near the edge of a thin panel. Use them to lock and release access panels, doors, and covers with a quarter-turn.

Rivet these wing head nuts into thin panels for a flush fit. They can be mounted without space between panels. A quarter-turn locks and releases access panels, doors, and covers.

The base flares out during installation, creating a backside flange in hard materials and near edges in panels up to 0.312" thick. Install with a flare-in installation tool and an arbor press.

These screws mount flush against the outer panel's surface for low-clearance applications.

An expanding rubber bushing damps vibration while holding panels together.