Move large, heavy sheets of plywood, fiberboard, cement board, and drywall with these nonmarring lifters. Unlike suction-cup and magnetic lifters, they will hold porous and nonmagnetic sheets.

A built-in pump generates more suction for lifting and holding heavier items than push-grip lifters.

Push down to create a vacuum and grip your items.

Use in pairs with a two-leg sling to transfer metal plates in a horizontal position. Unlike other plate-lifting clamps, these can pick up multiple plates at the same time.

Pads on these clamps prevent the grip from biting into the load.

Clamps can take a metal plate that is stacked horizontally and tilt it up 90° to lift vertically. After lifting, clamps can place the plate back down in the original position (plate can not be flipped over).

These magnets hold a load until you pull the handle and pry the magnet off.

Load these trucks from either side to make quick work of moving large quantities of long, flat material such as doors, partitions, and sheet stock.

These easy-to-clean, corrosion-resistant plastic trucks are reinforced with steel for strength. Removable rails allow you to configure them to accommodate a variety of long, flat loads.