These metric nuts have a barrel with multiple threads for secure thread engagement. Also known as U-style clip-on nuts.

A hex- or square-shaped barrel allows these clip-on nuts to be gripped with a wrench to hold them in place when tightening a screw. They have multiple threads for more thread engagement than low-profile clip-on nuts.

A hex-shaped barrel allows these clip-on nuts to be gripped with a wrench to hold them in place when tightening a screw. They have multiple threads for more thread engagement than low-profile clip-on nuts.

These nuts firmly clip onto the edge of panels and stay secure.

Slide these nuts on the edge of a panel and position them by hand. Also known as G-style clip-on nuts.

These nylon nuts are chemical resistant, nonconductive, and lightweight.

Snap these nuts into square holes in thin materials.

Access to both sides of the material is required for installation.

These wing-head screws have a clip-on nut that allows you to mount them near the edge of a thin panel. Use them to lock and release access panels, doors, and covers with a quarter-turn.

Press these wing head nuts into a closed-end hole or thick panel in applications where the back of the panel is inaccessible. A quarter-turn locks and releases access panels, doors, and covers.

Press these wing head nuts into the backside of a panel in applications where you have access to both sides of the panel. A quarter-turn locks and releases access panels, doors, and covers.

These rounded head nuts can be riveted into thin panels for a flush fit. They can be mounted without spaces between the panels. A quarter-turn locks and releases access panels, doors, and covers.

Install in soft material such as aluminum and low-carbon steel at least 0.036" thick with an arbor press or similar pressure tool.

The base flares out during installation, creating a backside flange in hard materials and near edges in panels up to 0.312" thick. Install with a flare-in installation tool and an arbor press.

Push the plunger to secure and pull to release for quick access.

Install these rounded head screws through a hole and thread on a retainer to keep secure—no special tools are required.

These brackets come in one piece that can be cut-to-size with a hacksaw.

Fit brackets together to assemble truck racks, gates, crates, and fences.

Fit these brackets through drilled holes in panels.

Use four brackets to support the top and bottom edges of panels without drilling holes in them.