Install these rounded head screws through a hole and thread on a retainer to keep secure—no special tools are required.

Install in soft material such as aluminum and low-carbon steel at least 0.036" thick with an arbor press or similar pressure tool.

Snap these screws into panels up to 0.125" thick—no tools are required for installation.

Brass binding barrels and screws are corrosion resistant in wet environments and electrically conductive.

An unthreaded barrel allows quick assembly with a press or a hammer.

Plastic binding barrels and caps are chemical resistant, nonconductive, and lightweight.

Angled under the head for a flush finish in countersunk holes.

Install in a cutout to create a secure joint between boards, butcher blocks, and countertops.

Pair these screws with a barrel you already have or couple with a different barrel to create a custom fastener. Made from 18-8 stainless steel, they are chemical resistant.

Pair with a barrel you already have or couple with a different barrel to create a custom fastener. Made from 316 stainless steel, they have excellent chemical resistance and can be used in saltwater environments.

Use these barrels with a screw you already have or pair with a different type of screw to create a custom fastener. Made from 316 stainless steel, they have excellent chemical resistance and can be used in saltwater environments.

Use these barrels with a screw you already have or pair with a different type of screw to create a custom fastener. They're zinc plated to resist corrosion in wet environments.

These include a barrel and a screw.

An unthreaded barrel allows quick assembly with a press or a hammer.

These binding barrels and screws have good chemical resistance.

Install these binding barrels and screws with a standard slotted screwdriver. They require a special tool to remove.

Sealed with PVC foam under the head to prevent leaks and keep contaminants out.

Lock the nose in the retracted position by pulling the knob and rotating it 90°.

Lock the nose in the retracted position by pulling the knob and rotating it 90°.