Prevent accidental actuation from bumps or jostles—these switches require you grip and twist a lever to turn them on or off. Install them in 30 mm dia. cutouts.

Rated NEMA 4, 13, and IP66, these metal switches are protected from washdowns and oil/coolant spraying. Install them in 30 mm dia. cutouts.

Thanks to their ability to handle higher current than switches with contact blocks, these switches are often found in applications from large motors to warehouse lighting systems.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Immediately cut power with a single push.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Simple to use, these switches actuate with a quick push.

A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

Install in 8 mm dia. cutouts.

Install in 10 mm dia. cutouts.

Actuate these switches with a quick push.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Rated NEC Classes I, II, and III, these switches have a housing that keeps fire and sparks in, so they won’t ignite gases, vapors, or dust. To save space on your panel, they can control multiple circuits.

Change the cover on these switches without replacing them entirely—they come with seven snap-on covers in different colors. The colors help you quickly identify switches without labels.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Immediately cut power with a single push.

A red light flashes when the actuator is pushed, making it easy to see from a distance. They're rated IP65 for protection from washdowns.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

These switches meet MIL-S-3950.

Built into a terminal block, these switches mount to DIN rail.

Snap these switches onto your DIN rail to mount them. With a toggle switch and receptacle combined, you can actuate power and plug in devices from a single box.

The wide surface of these switches makes them easy to press on and off, even if your hands are full and you need to use an elbow.

Rated IP67, these switches are protected from temporary submersion.

Rated IP67 for protection from dust and temporary submersion.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Choose an actuator and contact block to make your own 30 mm switch.

An infrared light beam senses the lightest finger contact to switch a circuit on or off.

To prevent accidental actuation and limit access to sensitive equipment, these switches require a key to turn circuits on or off. The contact block and actuator are all one piece, so they won’t separate in high-vibration applications.

Designed for use near ignitable gases, fibers, and dust, these switches have a housing that seals in anything that could ignite flammable material. They require a key to turn circuits on or off, preventing accidental activation and limiting access.

Rated NEMA 4 or IP66, these switches are protected from washdowns.

With a round key that is difficult to duplicate, these switches provide a higher degree of security than standard key switches.