Coated with aluminum oxide—the most common abrasive material, hard enough to sand steel and wood.

A selection of 40 emery and crocus sanding sheets are included in these assortments.

The soft abrasive is good for fine hand-polishing of metal surfaces that require the smoothest finish possible after an abrasive sequence. Also known as crocus cloth.

These assortments include three cut-to-length sanding rolls of various grits in a convenient dispenser.

The soft abrasive is good for fine hand-polishing of metal surfaces that require the smoothest finish possible after an abrasive sequence. Also known as crocus cloth.

The soft abrasive is good for fine hand-polishing of soft nonferrous metals. Also known as crocus cloth.

These sheets resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

Assortments include three cut-to-length sanding rolls of various grits that resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents.

Keep an assortment of sheets that prevent dust and debris from building up on the abrasive surface close at hand.

A cushioned layer lets you apply more even sanding pressure on your workpiece, creating finer and more consistent finishes.

Sized for tight spaces, these small pads sand flat and curved surfaces. They have a flexible foam layer that gives you more control over sanding pressure, creating finer and more consistent finishes.

The thick, abrasive-embedded nylon mesh construction flexes to compensate for uneven pressure as you sand, producing a consistent finish.

When you need to achieve a more consistent finish, choose nylon mesh sanding rolls over paper- or cloth-backed rolls.

Flexible enough to sand around curves and in corners, these sponges provide the comfort and control of a sanding block.

These sponges prevent debris from accumulating on the abrasive surface and keep operating temperatures low.

Evenly sand two surfaces at once.

Peel and stick to your sanding tool. When it’s time to change the sheet, peel it off.

Quickly attach, remove, and reuse.

Cut the length you need, then quickly attach, remove, and reuse.

A coating prevents dust and debris from building up on the abrasive surface.

Easy to attach and remove, these sheets grip the surface of your vacuum detail sander. Vacuum holes allow dust to get sucked up before it can build up and dull the abrasive surface.

Dust and debris won't build up on the abrasive surface.

A coating prevents dust and debris from building up on the abrasive surface.

Attach these sheets to pole sanders to smooth ceilings and walls. They’re covered in aluminum oxide, which is the most common abrasive for general use.

Smooth or shape work surfaces. Good for general purpose sanding, the aluminum oxide abrasive on these belts is tough and won’t crack under stress.

These belts resist deterioration when used with water or cutting fluids.

Avoid clogs when you're removing paint or rust. The widely spaced grains on these belts give dust and debris a place to collect so they won't build up on the surface.

When you need to achieve a more consistent finish, choose nylon mesh sanding belts over paper- or cloth-backed belts.

With a flexible, cloth backing, these belts resist tearing. 16" or wider, they’re for sanding large surfaces.

Press onto a compatible sanding tool or backup pad; peel off to remove.

The premium abrasive stays sharp longer.

Coated with either ceramic alumina or a premium form of aluminum oxide, these discs last longer, cut faster, and produce a more consistent finish than standard hook and loop discs.

Precision-shaped ceramic alumina discs abrade hard metals like stainless steel faster than standard ceramic alumina discs because of their sharp, outwardly pointed grit.

The abrasive-embedded mesh construction gives you more control over sanding pressure, creating finer and more consistent finishes.