A recess under the hex clinches a panel for a strong hold that won't push, pull, or twist out. When mounted with a lever press, the hex sits flush with the surface and the open end creates a through hole. These are also known as captive standoffs.

18-8 stainless steel standoffs have good corrosion resistance and are nonmagnetic.

Zinc-plated steel standoffs have some corrosion resistance.

For technical drawings and 3-D models, click on a part number.

Designed to fit in the limited space of compact electronics, such as laptops and hand-held devices, these standoffs have a recess under the head that clinches a panel while splines on the head bite in for an extra-stong hold. The open end creates a through hole. Standoffs have excellent wear resistance and may be mildly magnetic. Use a lever press to install.

For technical drawings and 3-D models, click on a part number.

Also known as captive standoffs, the splines on these bite into a panel for a permanent hold and the open end creates a through hole. They have good corrosion resistance and may be mildly magnetic. Use a lever press to install.

For technical drawings and 3-D models, click on a part number.

With the end permanently clinched in place, the prongs allow you to quickly snap a panel on and off these supports for repairs and upgrades. They have excellent wear resistance and are passivated for enhanced protection. They may be mildly magnetic. Use a lever press to install.

For technical drawings and 3-D models, click on a part number.

Once the end is permanently clinched in place, panels with keyholes easily slide on and off these supports for repairs and upgrades. Supports have good corrosion resistance and are passsivated for enhanced protection. They may be mildly magnetic. Use a lever press to install supports.

For technical drawings and 3-D models, click on a part number.

Also known as pilot pins, use these pins to position, pivot, and align components. To install, punch or drill a hole in sheet metal, then use a punch and anvil or arbor press to clinch the head to the metal.

Pins are passivated for added protection against corrosion and oxidation. The ends are chamfered for easy insertion.

PEM® TPS pins work on steel or aluminum sheets. Made of 18-8 stainless steel, they offer a balance of strength and corrosion resistance and may be mildly magnetic.

PEM® TP4 pins work on stainless steel sheets. Made of 400 series stainless steel, they resist wear and abrasion, but are not as corrosion resistant as 18-8 stainless steel pins. Pins may be mildly magnetic.

PEM® MPP pins work with most materials. Made of A286 stainless steel, they're our strongest captive pins, with corrosion resistance comparable to 18-8 stainless steel pins. They are nonmagnetic.

For technical drawings and 3-D models, click on a part number.

Often used in cell phones and laptops, these pins attach thin panels such as printed circuit boards to metal and plastic bases. Also known as PEM® TackPins.

PEM® T4 pins are used to attach sheets to stainless steel. They are made of 400 series stainless steel to resist wear and abrasion and may be mildly magnetic. Pins are passivated for added protection against corrosion and oxidation.

PEM® TA pins work with most materials. They are made of aluminum and are nonmagnetic.

For technical drawings and 3-D models, click on a part number.