These pens are pressurized to write at any angle, on wet surfaces, and in extreme cold.

Minimize the buildup of electrostatic charge.

Write at any angle in food-, pharmaceutical-, and cosmetics-processing plants—these pens contain metal and chemical additives that set off metal detectors and show up on X-rays if they fall into your line.

Made of aluminum, these pen-shaped engravers are lightweight to reduce writing strain.

These engravers have a wider range of depth settings and produce less vibration for smoother writing.

These engravers have a wider range of depth settings and produce less vibration for smoother writing.

Includes an engraver, four interchangeable tips, a tip holder, an air filter, and a portable case.

Melt surface material and create marks without vibration.

Includes a set of five or eight colors.

Includes a set of four colors.

A valve eliminates the risk of seepage caused by the expansion and contraction of a marker due to extreme temperature fluctuations.

You can leave the cap off of these markers for up to two weeks without them drying out.

The thin inch-long tip allows you to make clear marks in small and confined spaces.

Includes blue, green, orange, pink, and yellow highlighters.

Commonly used in food processing facilities, these highlighters are made of a plastic that can be detected with a metal-sensing device.

Often used for quality control and theft detection, the ink in these markers is invisible under normal conditions but fluorescent in ultraviolet light.

Marks remain intact when exposed to degreasing solvents such as mineral spirits, mineral oil, gasoline, and most alcohols.

Containing only trace amounts of chlorides and other halogens, these markers safely write on materials that are prone to stress cracking, such as stainless steel and titanium.

Wash the writing off your surface with water.

Make marks on natural and synthetic fabric.

Includes a set of five colors.

Choose only the colors you need. These rich colors won’t fade in sunlight or exposure to weather.

Choose only the colors you need. These paint markers work well even on dirty, rusty, and oily surfaces.

Mark surfaces that are exposed to extreme heat.

Write on wet surfaces or underwater. These paint markers also work well on dirty, rusty, and oily surfaces.

These long-life markers hold twice as much paint as our other fabric paint markers.

Operate hand-held PLCs and other pressure-activated screens (also known as resistive touch screens) in sanitary and food processing areas.

These paint crayons work well even on dirty, rusty, and oily surfaces.

Write on concrete, forgings, castings, and other rough surfaces with these paint crayons.

Marks written at room temperature will hold up through heating and cooling processes. Use on welds, ingots, castings, forgings, and other metal surfaces.

Low in chlorides and halogens, these crayons won't corrode or contaminate surfaces where degradation is a concern such as stainless steel. They're typically used in nuclear plants and oil and gas refineries.

These surface fillers come in a pen for precision application. After applying, use the LED on the back of the pen to instantly cure.

Fill these pens with paint for a precise and tidy touch-up.

Seal out moisture on scratched painted metal.

This ink is waterproof and dries quickly.

Test the surface energy (dyne level) of film and other nonabsorbent surfaces before printing, coating, or laminating. Also known as dyne pens.