System of Measurement
    System of Measurement
    Inch
    Metric
    Joint Type
    Joint Type
    Pin and BlockSpring
    U-Joint Type
    U-Joint Type
    SingleDouble
    For Shaft Type
    For Shaft Type
    Round
    Keyed
    Shaft Mount Type
    Shaft Mount Type
    Spring PinSet Screw
    Clamp On
    For Shaft Misalignment Type
    For Shaft Misalignment Type
    AngularParallel
    Maximum Operating Angle
    Maximum Operating Angle
    15°
    25°
    30°
    35°
    45°
    90°
    Operating Angle
    Operating Angle
    10°
    Maximum Speed
    Maximum Speed
    1,000 rpm
    1,500 rpm
    1,750 rpm
    Not Rated
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Keyway Width
    Keyway Width
    default
    1/8"
    3/16"
    1/4"
    3/8"
    1/2"
    Keyway Depth
    Keyway Depth
    default
    1/16"
    3/32"
    1/8"
    3/16"
    1/4"
    For Maximum Shaft Diameter
    For Maximum Shaft Diameter
    7/32"
    9/32"
    3/8"
    7/16"
    1/2"
    9/16"
    5/8"
    11/16"
    3/4"
    7/8"
    1"
    1 1/8"
    1 3/16"
    1 1/2"
    1 3/4"
    Parallel Misalignment Capability
    Parallel Misalignment
    Capability
    0.063"
    0.094"
    0.125"
    0.313"
    0.375"
    0.438"
    0.845"
    0.951"
    1.133"
    1.268"
    1.428"
    1.585"
    1.796"
    Not
    Rated
    Number of Set Screws Required
    Number of Set
    Screws Required
    2
    4
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    92 Products