When you can't drill a through hole, use one of these flanged receptacles to provide a permanent, blind hole for a quick-release pin.

Use these retaining caps to secure the ends of quick-release pins in holes that are oversized or out of round.

Screw these studs into a tapped hole and use them as a pivot point, hinge, shaft, or locator pin.

Use an arbor press or similar pressure tool to install these spring plungers into a panel.

Insert the nose into a panel; then thread on the nut and tighten using an installation wrench.

Hinge leaves fit into two cutouts (mortises) to mount flush with the door and frame.

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

Also known as bullet hinges, these hinges are the right size for tight spaces and narrow frames.

Plastic hinges are a lightweight alternative to metal hinges and provide smooth, silent operation.

These hinges with holes are spring loaded—pull the handle to retract the pin and disconnect a door; release the handle and the pin snaps back.

To make reconnecting doors easier than other pull release quick disconnect hinges, these have a keeper that holds the pin in a retracted position.

Remove the ring to pull out the pin.

To retract the pin and disconnect a door, squeeze the hinge handles together. Release the handles and the pin snaps back.

Fasten these brackets to ceilings, walls, beams, and joists to hang threaded rod.

Lock these brackets together with a pin or a bolt. They are often used on marine docks.

Also known as angle brackets.