Use these metal dowel pins as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Grooves run the full length of these pins for a firm hold that won't spin. Use them in place of standard dowel, spring, and taper pins to fasten parts. Also known as type A pins.

These spiral pins remain flexible after installation, so they absorb shock and vibration better than slotted spring pins. They work well in holes that are out of round.

Position, pivot, and align components. Also known as pilot pins and PEM® TP4, TPS, and MPP pins.

Screw the threaded end of these metric studs into a tapped hole and use the unthreaded end as a pivot point, hinge, shaft, or locator pin.

18-8 stainless steel studs have good chemical resistance.

These steel studs are zinc plated to resist corrosion in wet environments.

When installed, these keys fill oval keyways completely, reducing stress on the key and shaft. The rounded ends make it easy to slide gears, hubs, and other components into place. These are also known as feather keys.