To remove these pins, thread a screw or tool into the tapped hole, then pull them out.

A spiral groove cut into these pins relieves trapped air but stays in 360° contact with the hole for a secure fit that's easy to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

Create a custom headed pin with your choice of material, dimensions, and end type.

Screw these studs into a tapped hole and use them as a pivot point, hinge, shaft, or locator pin.

These studs are also known as hanger bolts—use them to hang, mount, and fasten parts to wood structures.

316 stainless steel studs have excellent resistance to chemicals and salt water.

These steel studs are zinc plated to resist corrosion in wet environments.

These studs have good chemical resistance. Weld them to stainless steel surfaces.

A hollow center allows these studs to be used as an axle, a vent, or a passageway for wiring.

Retract the nose by pulling the knob.

Thread onto machinery or attach a knob or handle to the threaded spindle.

Install these spring plungers with a screwdriver—they're slotted on one or both ends.

Install with a hex key for more torque than slotted long-nose spring plungers.

Install with a driver.

Mount ball-nose and long-nose spring plungers to fixture surfaces.

Without a head to get in the way, these screws fit in tight spaces where standard shoulder screws cannot. Either thread them in a countersunk hole for a flush mount, or install them with the shoulder sticking out to use them as pins or dowels for aligning and locating components.

Bolts are beveled under the head for a flush finish in countersunk holes.

Also known as double expansion anchors, these expand from both sides for full contact and a secure hold.

Also known as caulk-in anchors, these stay secure when there's not much material to hold.

A zinc plating provides corrosion resistance in wet environments.