We will reply to your message within an hour.
To remove these pins, thread a screw or tool into the tapped hole, then pull them out.
The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.
A spiral groove cut into these pins relieves trapped air but stays in 360° contact with the hole for a secure fit that's easy to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.
Threads on these pins stick out for easy removal from blind holes. Tighten the hex nut to draw the pin out.
Choose a material, head type, end type, and size to create a custom pin.
Create a custom headed pin with your choice of material, dimensions, and end type.
Screw these studs into a tapped hole and use them as a pivot point, hinge, shaft, or locator pin.
These studs are also known as hanger bolts—use them to hang, mount, and fasten parts to wood structures.
These steel studs are zinc plated to resist corrosion in wet environments.
18-8 stainless steel studs have good chemical resistance.
These studs have good chemical resistance. Weld them to stainless steel surfaces.
Weld these studs to uncoated steel surfaces.
Pass these studs through a hole and weld them in place.
Add a stud to thin material when you only have access to one side.
316 stainless steel studs have excellent resistance to chemicals and salt water.
Install these spring plungers with a screwdriver—they're slotted on one or both ends.
Install with a hex key for more torque than slotted ball-nose spring plungers.
Install with a hex key for more torque than slotted long-nose spring plungers.
Install with a driver.
Slotted on both ends for installation with a screwdriver.
Mount ball-nose and long-nose spring plungers to fixture surfaces.
Install spring plungers from the nose end without depressing the nose.
Without a head to get in the way, these screws fit in tight spaces where standard shoulder screws cannot. Either thread them in a countersunk hole for a flush mount, or install them with the shoulder sticking out to use them as pins or dowels for aligning and locating components.
Stainless steel thumb screws have excellent corrosion resistance in most environments.
Drive these tools with a hammer to expand anchors.
Also known as caulk-in anchors, these stay secure when there's not much material to hold.
Use these buttons to support and position workpieces and fixtures from the bottom or side. Their hex shape lets you screw them into a threaded hole with a wrench or socket.
Thread in a screw, handle, or other part to create the right size and shape guide pin for your application.
These have a go gauge on one end and a no-go gauge on the other end.
These gauges come with a certificate of calibration traceable to NIST that states they’ve passed a test for accuracy.
Weld threaded studs and pins to steel and stainless steel without damaging the opposite side of the material. This process uses heat from resistance to an electrical current.