McMaster-Carr logo
    Clear All
    System of Measurement
    System of Measurement
    Metric
    Thread Size
    Thread Size
    click to learn more about
    Show
    Thread Type
    Thread Type
    Material
    Material
    Stainless Steel
    Steel
    Base Diameter
    Base Diameter
    default
    3.7mm
    4.5mm
    Threading
    Threading
    Fully Threaded
    For Hole Diameter
    For Hole Diameter
    2.5mm
    For Minimum Length Between Hole Center and Sheet Edge
    For Minimum Length Between
    Hole Center and Sheet Edge
    5mm
    5.5mm
    Hardness
    Hardness
    Rockwell C70
    Not Rated
    RoHS (Restriction of Hazardous Substances)
    RoHS (Restriction of
    Hazardous Substances)
    RoHS Compliant
    Pitch
    Pitch
    0.45mm
    Drill Bit Decimal Size Equivalent
    Drill Bit Decimal
    Size Equivalent
    0.098"
    0.0984"
    Drill Bit Size
    Drill Bit Size
    2.5 mm
    No. 40
    Gauge Type
    Gauge Type
    Go
    No-Go
    Thread Fit
    Thread Fit
    Class 6g
    Tensile Strength
    Tensile Strength
    click to learn more about
    Not Rated
    Thread Spacing
    Thread Spacing
    click to learn more about
    Thread Length
    Thread Length
    4mm
    6mm
    8mm
    10mm
    13mm
    16mm
    Thread Pitch
    Thread Pitch
    click to learn more about
    0.45 mm
    REACH (Registration, Evaluation, Authorization and Restriction of Chemicals)
    REACH (Registration,
    Evaluation, Authorization
    and Restriction of Chemicals)
    REACH Compliant
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    11 Products