Rollers have a groove that provides clearance to cut flared tube ends with little material loss.

Unlike standard tube cutters, which cut from the outside, these cutters slide into tube ends to cut and vent from inside. They’re often used to punch holes in plugged tubing to prevent pressure buildup, which helps you comply with ASME PCC-2 standards for repairing pressure equipment and piping.

Move the adjustable collar up and down the cutter to set it to the depth you need. Flatten the blade against the cutter body to slide into your tubing, then use a wrench to turn the hex shank at the end of the cutter. Turning the cutter clockwise engages the blade; counter-clockwise retracts it. The steel blade is strong enough to cut through tube walls in one pass, and is durable enough for multiple cuts. A pin and set screw hold the blade in place, so when it becomes dull, it’s easy to replace.

Made of materials that are FM approved, these cutters satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. They're also nonmagnetic.

Warning: Do not use these tools in direct contact with acetylene.

These heavy duty cutters have an iron frame for exceptional durability.

One-wheel cutters require a 360° turn for a complete cut.

Four-wheel cutters require only a 180° turn to make a 360° cut.

Two-handle cutters are for two-person operation.

Ridgid Number 202 cutter has extra-wide rollers to resist wobbling and make straight, clean cuts.

Cut pipe with just 90°-110° of handle swing and 4" of clearance.

Ratchet action moves the cutter 360° around a pipe with only 10° of handle swing.