These expansion joints have a double-bulb design for extra movement and vibration absorption. The flanged ends rotate for easy bolt hole alignment during installation. They mate with a same-size flat-surface Class 150 flange without the need for a gasket. Joints have a flexible body that is reinforced with nylon for added strength.

For technical drawings and 3-D models, click on a part number.

The PTFE body on these expansion joints has a super-smooth surface that stands up to corrosive chemicals. Joints have a triple-bulb design that provides excellent vibration absorption, reducing stress on your piping system. The flanges mate with a same-size flat-surface Class 150 flange without the need for a gasket. Limit rods are attached to the flanges to prevent overextension.

For technical drawings and 3-D models, click on a part number.

Because the flanges are molded into the body for a wide sealing surface, these joints provide a tighter seal than other expansion joints. Each flange is supported by a zinc-plated steel plate. Flanges mate with a same-size flat-surface Class 150 flange without the need for a gasket. Joints reduce stress, vibration, and noise in metal piping systems by providing a point of flexibility to absorb movement. They have a flexible body that is reinforced with cord for added strength.

For technical drawings and 3-D models, click on a part number.

These joints reduce stress, vibration, and noise in plastic piping systems by providing a point of flexibility to absorb movement. Joints provide a tighter seal than other expansion joints because the flanges are molded into the body for a wide sealing surface. Each flange is supported by a zinc-plated steel plate. Flanges mate with a same-size flat-surface Class 150 flange without the need for a gasket.

For technical drawings and 3-D models, click on a part number.

These joints weld to unthreaded pipe or another butt-weld fitting for a leak-resistant, permanent connection. They reduce stress, vibration, and noise in metal piping systems by providing a point of flexibility to absorb movement.

For technical drawings and 3-D models, click on a part number.

These joints are designed for vertical use to reduce stress, vibration, and noise in drain, waste, and vent systems. Slip them over the end of your pipe and tighten the band clamps for a secure hold. They have an internal stop to ensure pipe is in the proper position.

For technical drawings and 3-D models, click on a part number.