Soft and easy to install, this insulation restricts absorption of water, air, and gas. It is often used on cold and hot water lines and refrigeration lines.

This common insulation material is typically used on hot and cold water lines and in process piping.

Even at high temperatures, these tubes remain flexible to stretch over components without tearing. They restrict absorption of water, air, and gas and are typically used on hot and cold water lines and electrical components.

Hook-and-loop fasteners make it easy to install, remove, and reuse this flexible insulation. Use on steam, hot water, and process pipes and fittings.

Very rigid with a 0% water absorption rate, this insulation is unaffected by corrosive environments, organic solvents, and most acids. It is typically used in chemical-processing systems and underground lines.

This very rigid insulation offers the lowest heat-flow rate of our pipe insulation and restricts absorption of water, air, and gas. It is typically used in process piping and chiller plants and performs best in applications below 50° F.

Guard insulation from heavy impact and chemical exposure. This metal jacketing is corrosion resistant and often used outdoors.

Wrap pipes, tubing, and fittings to prevent condensation from forming. These strips are for use on copper, iron, and steel.

An alternative to jacketing, these coatings create a vapor barrier and protect from conditions outdoors. They are often used on irregularly shaped surfaces, such as fittings, flanges, and valves.

Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

Rated for a maximum heat output of 900° F, these heaters are often used for thawing frozen pipes and rapid spot heating.

With a cable that supplies the same wattage along the entire length, these heaters remain consistent regardless of the surrounding temperature. All require a temperature switch or controller to regulate heat output.

Also known as self-regulating heat cable, these heaters automatically adjust heat output at different points along their length to account for differences in environmental temperature.

Keep the liquid inside your hose from freezing, maintain your liquid’s viscosity, and prevent condensation in chilly environments.

Clip these saddles around the outside of strut channel for a quick way to route insulated tubing and pipe. Lips on either end of the saddle protect insulation from abrasion if the pipe should move.