Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

Rated for a maximum heat output of 900° F, these heaters are often used for thawing frozen pipes and rapid spot heating.

With a cable that supplies the same wattage along the entire length, these heaters remain consistent regardless of the surrounding temperature. All require a temperature switch or controller to regulate heat output.

Also known as self-regulating heat cable, these heaters automatically adjust heat output at different points along their length to account for differences in environmental temperature.

Keep the liquid inside your hose from freezing, maintain your liquid’s viscosity, and prevent condensation in chilly environments.

Stick these flexible heat sheets to container surfaces to warm contents without direct contact.

Less than 0.015″ thick and highly conformable, these heat sheets warm components in tight spaces within complex designs.

For more durability than other adhesive-mount heaters, a thick layer of fiberglass-reinforced silicone rubber encases the heating element.

The heating wire in this hose warms adhesives or paraffin wax to keep them flowing. Pair it with the matching temperature controller to set the temperature.

Heat chemicals to prevent them from freezing or becoming too thick. With a self-regulating heating wire, the liquid inside this hose stays warm and keeps flowing.