Guard insulation from heavy impact and chemical exposure. This metal jacketing is corrosion resistant and often used outdoors.

This common insulation material is typically used on hot and cold water lines and in process piping.

Soft and easy to install, this insulation restricts absorption of water, air, and gas. It is often used on cold and hot water lines and refrigeration lines.

These kits insulate one P-trap and two stop valves to reduce the risk of burns from accidental contact with hot pipes under your sink. The molded, flexible pipe covers are ADA compliant when properly installed.

Even at high temperatures, these tubes remain flexible to stretch over components without tearing. They restrict absorption of water, air, and gas and are typically used on hot and cold water lines and electrical components.

These rigid, lightweight melamine foam tubes are wrapped in an ISO Class 5 and Fed. Spec. Class 100 clean room jacket that is suitable for sanitary and washdown applications. They’re typically used on cold and hot water piping and with refrigeration systems.

Melamine has a lightweight construction that allows quick and easy installation. Use on cold and hot water piping and with refrigeration systems.

Superior in strength and durability, these thin strips insulate as well as protect personnel from accidental contact with hot pipes. Use for exhaust, hot water, and process pipes.

This very rigid insulation offers the lowest heat-flow rate of our pipe insulation and restricts absorption of water, air, and gas. It is typically used in process piping and chiller plants and performs best in applications below 50° F.

An alternative to jacketing, these coatings create a vapor barrier and protect from conditions outdoors. They are often used on irregularly shaped surfaces, such as fittings, flanges, and valves.

Wrap pipes, tubing, and fittings to prevent condensation from forming. These strips are for use on copper, iron, and steel.

Clip these saddles around the outside of strut channel for a quick way to route insulated tubing and pipe. Lips on either end of the saddle protect insulation from abrasion if the pipe should move.

These heaters require a power-connection kit.

Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

These heaters require a separate temperature switch or controller to regulate heat output.

Rated for a maximum heat output of 900° F, these heaters are often used for thawing frozen pipes and rapid spot heating.